Hi listers,
This is my first question from this new address.
I know there was a thread at one point or another, but I'm a little frustrated
with this chronic problem.
My TR3A has about 4000 miles on a fresh engine. I rebuilt the carbs when I did
the engine and thought everything was OK.
I understood that the Triumph motor needed a heavy choke when first starting,
but it has always run rough until it reached temperature.
This rough starting has gotten worse over the last few months so that even at
temperature it doesn't settle down completely.
Last night I did a little investigating. While it was idling rough, I pulled
the wires off cylinders 3 and 4 with no change. I pulled the plugs and found 3
and 4 clean while 1 and 2 were extremely rich....rear carb??? I checked the
float bowls, needle valves and pistons on the H6's....all seemed OK. Installed
fresh plugs...no change. Cleaned the points and contacts in the distributor
cap...no change.
Hmmmmm....Should I replace the plug wires....distributor cap....reset the
valves??
What gives?...I'm just a little frustrated with this. Has anyone else had this
problem?
TIA
Bob Stahlbush
_______________________________________________
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs mailing list
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
|