At 07:44 PM 10/2/2007, Joe Laurito wrote:
>Speaking of oil leaks, my TR3 weeps around the push rod tubes. Any easy way
>of fixing that or do I live with it?
I know of several ways. Each has variable success.
1. Use JB Weld. Put a thin fillet of it around joint under spark
plug. Must remove paint first.
2. Do same around of top, inside valve cover. I don't like this
because sometimes it will come loose and get into engine.
3. Use Loctite green - it is the kind that wicks into a joint. You
must have all oil off the surfaces,, which means liberal application
of lacquer thinner and compressed air to the joint inside the valve
cover and under the spark plugs. Then just apply a little of this
stuff to the joint. Works if the head is totally clean - may or may
not work otherwise, depending on how clean you can get the joint.
4. I've had my machine shop make up a swaging tool that we use after
any head milling. Basically it is two cones, top and bottom, pressed
lightly by a press. Head must be off of course.
>
uncle jack
------------------------------------------------
No Virus Found In This Message
Scanned at barracuda.geneseo.net
_______________________________________________
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs mailing list
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
|