> If you
> want a confidence test, take two pieces of your surplus sheet
> steel, weld them together, then go beat the begeevies out of
> it with a sledge hammer, or put one side in the vice and try
> to peel the other one away from it, or try bending it right
> at the weld 60 times.
This is basically standard practice when learning to weld. Make a weld then
test it to destruction. If the weld fails before the metal on either side,
you didn't do it right and you have to do it again until it's right.
Randall
_______________________________________________
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs mailing list
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
|