triumphs
[Top] [All Lists]

Re: [TR] Rebuilt carb start up

To: <TeamTiger21@aol.com>, <triumphs@autox.team.net>
Subject: Re: [TR] Rebuilt carb start up
From: "Michael Marr" <mmarr@notwires.com>
Date: Fri, 14 Sep 2007 10:22:14 -0500
> OK I had the carbs rebuilt by Paltech and they are beautiful. Put them on
> last night and I can barely get the car to start let alone run. It 
> backfires
> through the rear carb. Didn't touch the distributor. I have not put light 
> oil in
> the pistons reservoirs yet. Thoughts?


I am wondering why you have not put in the damper oil.  It would be 
difficult to tune the carbs without it.  Also, you have not said whether 
these are SUs or Strombergs, although I suspect they are the former.  If SUs 
(I know nothing about Strombergs), did you:

a) Make sure the pistons slide freely throughout the whole of their travel 
(i.e center the jets)?
b) Adjust the jets to the correct initial position (Screw the nut in until 
the top of the jet is flush with the bridge and then back it out two full 
turns)?
c) Make sure the float level is correct (see previous recent correspondence 
on this topic)?
d) Make sure that all of the throttle and choke linkages are free and not 
binding?

But first, put the oil in the dampers.

Mike
_______________________________________________

This list supported in part by the Vintage Triumph Register
http://www.vtr.org

Triumphs mailing list
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs

<Prev in Thread] Current Thread [Next in Thread>