In a message dated 9/9/2007 1:48:17 PM Central Daylight Time,
anabil007@comcast.net writes:
> Hi Listers,
> I am trying to replace the hand brake on our 1970 TR6, the
> old one failed when the action rod pushed through the rubber "button"
> and locked the brakes ON ... I had to remove the pivot bolt to get
> them free. It was then I discovered the old hand brake was from a
> TR4. I found a "correct" TR6 hand brake from a donor car (original)
> and all went well until I tried to reattach the brake cables ...
> there is simply not enough slack to do that ... and the cable
> must turn 90 deg to enter the Y connector. I released one of the
> cables from the rear drum attachment point but still could not get it
> to work.
> Any help is clearly appreciated ...
>
>
Did you try attaching the cables before mounting the handbrake lever on the
pivot bolt? That technique works well for me (although the whole mechanism is
a bit "fiddly" and having the cables attached worsens the issue but it is
still workable)
Dave
_______________________________________________
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs mailing list
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
|