In a message dated 8/29/2007 12:57:22 P.M. Eastern Daylight Time,
Dave1massey@cs.com writes:
(RUST?!!! WHAT
RUST?!!!)
Ugly has very little RUST if ANY! Just a little in the bottom of the doors
effecting the original paint. OK, hooked up a jumper cable from the left
tail light housing to the exhaust pipe and all lighting functions then appear
to
operate normally. Take off the cable and we go back to rear end Disco
Lights! What would be next? Remove the whole light assembly? Need a Wedge
Type
Guy here. Not seeing any real "Ground Connections" to clean up. Not
interested in tearing Ugly's whole rear end up unless it is required.
Thanks a Bunch,
Darrell
************************************** Get a sneak peek of the all-new AOL at
http://discover.aol.com/memed/aolcom30tour
_______________________________________________
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs mailing list
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
|