My workshop manual says to orient the pistons according to a 1/32" split in
the skirt. My new pistons have no such split, nor did the old ones, and
there is no indication on the crown of the piston as to how these should be
oriented relative to the bearing caps, etc. The old ones were marked STD with
86MM bores, so I assume they were TR4, and the new ones are 87MM. Can
someone
shed some light on this?
TIA
David Lylis
69 TR6 CC26160L
60 TR3A TS74461LO
************************************** Get a sneak peek of the all-new AOL at
http://discover.aol.com/memed/aolcom30tour
_______________________________________________
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs mailing list
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
|