Listers,
I have a fiberglass gearbox tunnel (which doesn't fit worth a damn)
which doesn't seem to seal properly. The PO replaced the pax side floor
board but it didn't have a cutout for the handbrake. I cut a hole in
the floor, but something doesn't seem right. The gbx cover has a flat
area into which the h'brake grommet is apparently intended to fit.
However, if I cut the gbx cover, it'll leave an open area for water, etc
to pool on the floorboard inside the grommet. And that makes no sense.
WTF, over?
TIA
jim
--
J.C. Hassall
Blacksburg VA
64 TR4 in autox preparation
95% finished, 90% to go
_______________________________________________
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs mailing list
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
|