Hi Paul-
Wire feed speed usually depends on what you're welding. Does your welder
have variable speeds? Lotsa variables; in general, the thicker the metal,
the higher the speed. Wire diameter makes a difference, too. There's got
to be a chart out there to give you some general parameters. Check with
your local welding supply store. Meanwhile, I found the following:
http://www.mig-welding.co.uk/wire-speed.htm
It's a video with explanation. Hope this helps-
Best,
Skip Gurnee
64 TR4, 66 TR4A, 70 TVR
> If I squeeze the trigger of my mig gun for 1 second, they tell me, that 1
> 1/2" of mig wire should come out. Is this about right?
>
> Thanks,
> Paul Dorsey
> 60 TR3
_______________________________________________
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs mailing list
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
|