Sounds to me like you will need to determin proper hole diameter and mig weld
in a patch plate. Lots of stress at this wiper mounting plate.
Dan
Paul Dorsey <dorpaul@negia.net> wrote:
I'm sure others have had this problem, and if they found a satisfactory
solution then I'd like to hear from them:
It seems that the body holes for the wipers have become larger over the years,
and this even allows part of the rubber gasket to fall into it!
Thanks, Paul Dorsey
60 TR3
_______________________________________________
adcronin@ameritech.net
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs mailing list
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
Planning & Development Services
A. Daniel Cronin
248 761-2673
_______________________________________________
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs mailing list
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
|