Greetings List,
I recently had my drive shaft balanced. Sadly, after and not before I
read what was in the Bentley manual about the drive-shaft, learning
about the matching arrows.
My arrows are not pointing at one another but opposed, one on top and
one on the bottom. the u-joints seem to be in the same plane as they
would be if the arrows where matching. is this OK? Or, should I take
action and if so what. I defer to the wisdom of the list.
Thanks
Bill Quincy
Wichita Kansas
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|