I've done it on my IRS4A so it can be done but as you say it's really a
tight fit. I seem to recall that it came out the back however and yes the
exhaust must be removed. I also seem to recall having to persuade it some.
I'll just confirm it's not easy but doable.
JVV
----- Original Message -----
From: "R. Ashford Little II" <70TR6@mindspring.com>
To: "6pack" <6pack@autox.team.net>; "Triumph Email List"
<Triumphs@autox.team.net>
Sent: Wednesday, May 02, 2007 6:49 PM
Subject: [TR] TR6 driveshaft removal?
> A buddy of mine is in my garage attempting to get his driveshaft out of
his
> 74 TR6 to change the U-joints. He said the book said that if you remove
the
> exhaust system then the shaft can come out from the front. Obviously he
is
> having an issue. The clearances are close, but Shawn and I are wondering
if
> there is a trick that he needs to know about?
>
>
>
> Thanks for your replies, and the sooner the better or else he walks to
work
> in the morning.
>
>
>
> R. Ashford Little II
>
> 6-PACK Membership Secretary
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|