Thanks Jack!
I think you can put me down for two sets. Will confirm, shortly.
Joe (A)
FOT List:
> Commercial message, kind of -- I know of no other way to get this
> message out to the Triumph community.
>
> We are putting together an order for Southwick aluminum hubs. We must
> have orders for 20 pairs in order to make the run, because we must
> purchase an entire bar of aluminum for the run and it is quite
> costly. These are made only about once every two years.
>
> The advantages of these hubs are 1) stronger, 2) lip seal on inner
> side, 3)heavier duty Timken bearings, 4) choice of stud size for the
> competition minded.
>
> The set of hubs consists of two aluminum hubs, your choice of wheel
> stud length and diameter, all new Timken bearings of heavier design
> than originals, inner lip seals, and dust caps for the outer ends.
> The price will be $450, shipping point Coal Valley, Illinois.
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|