Correct; The black wires are the ground and it should be grounded on one of
the post with that c - type bracket on the back of the guage.
al
----- Original Message -----
From: "jim hearn" <jimhearn1@comcast.net>
To: <triumphs@autox.team.net>
Sent: Tuesday, October 17, 2006 1:43 AM
Subject: [TR] Need to know what is connected to the voltage stabilizer
>I have a 1974 TR6. I just replaced the voltage stabilizer and now I
> don't have wipers, temp gauge and gas gauge working and they were
> before. All three of these are connected to the stabilizer. I had the
> dash apart and there was a connection with three black wires that I
> wasn't sure where it had been connected. I got a little careless not
> knowing where this connection with the three black wires goes. Can
> anyone help me out and tell me what is attached to the stabilizer other
> than the plug in leads. The plug in leads I swapped over from one to
> the other so I couldn't have gotten these mixed up. I'm wondering if
> the three black wires (one connector) attach (grounded) to the body of
> the stabilizer. Any help would be greatly appreciated. Thanks, Jim
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|