triumphs
[Top] [All Lists]

[TR] Revington ack and pinion.

To: triumphs@autox.team.net
Subject: [TR] Revington ack and pinion.
From: "T. S. White" <tswrace@pacbell.net>
Date: Sat, 30 Sep 2006 06:18:24 -0700
Well after months of effort and repeated failures to correct the bump 
steer in my converted Pinto rack and pinion steering I surrendered.  I 
am installing the Revington rack and pinion.

A note on this system is the need to install a grease zerk in the plug 
for the pinion housing.  A short zerk will not allow the grease gun to 
engage.  I found a zerk in my parts collection that had an i/2" extended 
shank.  This would allow the grease gun to engage but with the rack 
mounted in place it would be impossible to grease it during normal 
service.  The grease zerk points at a 45 degree angle upwards toward my 
radiator.

So I searched the internet.  I found an extended zerk in a coupler.  The 
manufacturer was a food processing machinery manufacturer.  Their rep 
could not identify the product and could not sell me one anyway.

So yesterday I stopped at Knox Industrial Hardware.  They had a 
selection of grease fittings that had extensions.  The longest one, 1", 
had a screw in zerk.  So I got a 90 degree zerk to replace the straight 
one in the extension.  Now the zerk will point down from the rack at 45 
degrees and I can reach it with the grease gun.
-- 
Best regards,
Tom


===  This list supported in part by The Vintage Triumph Register
===     http://www.vtr.org



<Prev in Thread] Current Thread [Next in Thread>
  • [TR] Revington ack and pinion., T. S. White <=