Thanks Randall, that's what I was thinking, but there is an inner lip that made
me unsure. My original seal was within a metal "frame" closed at both ends.
Ian
-------------- Original message ----------------------
From: "Randall" <tr3driver@comcast.net>
>
> > The old seal innards had aged and disintegrated when I took the
> > cover off. I think I know which way round the replacement should
> > go, but I am (obviously) not 100% sure. I have attached 2 pics (I
> > hope). I would appreciate opinions on #1 or #2.
>
> Unfortunately, you cannot send graphics (or indeed any attachment) through
> the list.
>
> Your new seal should have a closed side and an open side, the open side goes
> towards the inside of the engine.
>
> Randall
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|