In a message dated 7/4/2006 9:26:20 P.M. Eastern Standard Time,
rgperry@earthlink.net writes:
The rear hardtop mounting bolt holes have an adjusting nut. I assume that
the adjusting nut raises and lowers the mounting height of the rear mounting
deck of the hardtop. How does one know when it is adjusted properly?
>From the publication "Fitting instructions for the Triumph TR6 Hard Top Kit":
"tighten rear deck adjuster screws as necessary to give a 1/16" clearance
between hard top and rear deck panel."
FYI, TRF has pretty good illustration of Hard top components:
_http://www.zeni.net/trf/TR6-250GC/239.php_
(http://www.zeni.net/trf/TR6-250GC/239.php)
and its all in stock.
My hard top has been off the car for 5 years - putting it on now - TRF had
all the hardware I couldn't find.
Cheers
Jack Mc
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|