That's probably the hardest job to do on a Spitfire. Many an
axle/hub/carrier has been destroyed by hydraulic presses and the like when
trying to do it without the proper fixtures. And even then, many still get
destroyed.
Don't underestimate this job.
----- Original Message -----
From: "Stasyszen, Jerry" <JStasyszen@odmhsas.org>
Subject: Wheel bearing problem
>I have a new little dilemma here, I an replacing the rear wheel
> bearings on the rear end. Is this very difficult? I have replaced front
> and rear wheel bearings on US cars but not on a Spitfire, I will also be
> replacing the U-Joints at the same time.
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|