In a message dated 4/15/06 9:28:54 AM Eastern Daylight Time,
tr4a2712@yahoo.com writes:
> Regarding your procedure for placing the gasket on
> the liner prior to placing
> in the block.
NO, place the gasket sealer on the gasket, then place
the preped gasket into the ening carfully to insure
proper position. THEN install the liners carfully &
EVENLY so not to damage the Fig.* gasket. THEN install
the hold down hardware.
Cosmo,
I finished prior to getting your reply. All worked out well, I installed the
fig8 gasket of each set of two liners, they both offered up to the block
smoothly, no need to even tap in. I did dress all surfaces. The deck hieght
(.005")
was the same, with and without the dressing. All went so smooth I even had
time to put the pistons in. By the end of the week we'll see if it did actually
as smooth as it seems.
Thanks again Ed (58TR3A)
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|