Followup to my previous carb question:
I noticed that the original TR4 spare parts manual actually shows the pivot
pin with a retaining clip - but the Moss online catalog just shows a pin
(Item 31 on TR4 ZS carb page). I also pulled a carb off my other TR4
project and it had the same simple pin, no clip arrangement. Based on the
failure I had, it seems that a clip could be useful. Any list thoughts? I
probably could fabricate some type of simple clip out of brass stock if a
real pin/clip replacement source is unavailable.
Thanks again,
Randy
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|