I just drilled and tapped mine, figuring that if it wasn't thick enough to
hold, I'd at least be able to occassionally push some grease in with a
needle. But they held just fine, so far.
Geoff Branch
----- Original Message -----
From: <BCAH@aol.com>
To: <spridgets@autox.team.net>
Sent: Monday, March 13, 2006 2:31 AM
Subject: modifying lower link
>I was planning on adding an additional grease fitting to the welch plug on
> the lower link where the fulcrum pin goes.Any hints? Can I pull the welch
> plug
> out and put in a new one if I mess it up? Is a copper washer needed? Any
> drill sizes I should start with? Any thoughts would be
> appreciated,--------------Bob C
|