Thanks Richard, I'll grease em all over:) John
Richard Seaton wrote:
> John, grease the urethane bushings any place where metal touches the
> bushing inside and outside, and use anti seize inside the distance
> pieces where the bolts go.
>
>
>
> Richard Seaton
> RSH17@msn.com
> View My 1969 TR6 restoration @
> (http://groups.msn.com/Richards69TR6Restoration)
> OR
> http://www.triumphowners.com/registry.cgi?sectionID=111014&vehicleID=92
>
>
>
>
> ----Original Message Follows----
> From: John Mitchell <jmitch@snet.net>
> Reply-To: John Mitchell <jmitch@snet.net>
> To: 6 Pack <6pack@autox.team.net>, "triumphs@autox.team.net"
> <triumphs@autox.team.net>
> Subject: Poly Trailing Arm Bushings
> Date: Sun, 05 Mar 2006 09:30:20 -0500
>
> I'm installing polyurethane trailing arm bushings and was
> wondering what I'm supposed to grease. Is it the outside of the
> bushing where it goes through the trailing arm, or the bolt and metal
> tube going through the bushing. Thanks for any help. John Mitchell
> 76 TR6
>
> Your messages not reaching the list?
> Check out http://www.team.net/posting.html
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
=== unsubscribe/change address requests to majordomo@autox.team.net
|