>When I initially went to install the slave cylinder, the piston was so far
>out that I couldn't attach the pushrod. I had a hard time getting it to
>move at all, but eventually it went far back into the cylinder. I didn't
>take a precise measurement, but it seemed like more than an inch.
I'm thinking out loud, so forgive me if I'm off base, but is it possible to
mount the slave cylinder on the wrong side of the mounting bracket thingie?
I'm too lazy to go look at mine.
John
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|