tr3 door gap revisited

["Paul Dorsey" <dorpaul@negia.net>]

I'm now at that point again where establishing door gaps in my TR3 is
critical.  Ideally, with the sills installed, I'd like to evenly place about
3/16" door gap all the way around.  However, since the front wing on the
side I am doing (of course, one side at a time) has been removed, I am a
little bit leary that it may not turn out even on both edges of the door.

Or is it imperative that I install the front fender/ wing to arrive at the
proper door gap?
Thanks,
Paul Dorsey
60 TR3A