In a message dated 7/22/2005 1:33:47 AM Central Standard Time,
rtedder101@cox.net writes:
> On the engine side of the 1969 TR6 fascia panel and below and to the right
> of the speedometer there is a bracket apparently for the key lamp installed
> from CC50000. Of course the wiring harness for the 1969 does not include a
> bulb holder for this lamp. My question is. If you use the 1969 door switch
> P/N 625561, and install the transmission tunnel lamp, is there any reason
> why you can't add the bulb-holder (TRF P/N LUCAB302), and also, on the
> right side TRF p/n LU54364380? That is, while connecting the new
> bulb-holder between the (pw) wires supplied.
>
You will need a two wire bulb holder. One that insulates the bulb base from
the fingers. I did this very thing on my 71 but at the moment I can't tell you
What I did and what parts I used. But it can be done.
Dave Massey
|