| To: | Michael Marr <mmarr@notwires.com> |
|---|---|
| Subject: | Re: Align bore. |
| From: | "T. S. White" <tswrace@pacbell.net> |
| Date: | Tue, 31 May 2005 05:33:06 -0700 |
Aline honing/boring is not performed to correct block warpage. It is
done to improve the factory tolerances on the main caps in the block.
This reduces friction the enemy of horsepower. You can also align hone
the cam bearings.
--
Best Regards,
Tom
|
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | 'gator vinyl-the story so far, Paradise Music |
|---|---|
| Next by Date: | Fw: Re:Align Bore, Wayne Lee |
| Previous by Thread: | Re: Align bore., Michael Marr |
| Next by Thread: | Triumphs in Ireland?, Jeremy Kinney |
| Indexes: | [Date] [Thread] [Top] [All Lists] |