In a message dated 5/4/2005 9:42:29 PM Central Standard Time,
guy@genfiniti.com writes:
> Is it wise to use worm drive clamps to secure the rubber gaiters to the
> rear axle shafts of a TR IRS car?
>
> When I took them apart for reconditioning, they were secured by wire.
> I'd like to switch to a worm drive clamp, but fear it may throw off the
> centrifugal balance when these things turn at high speeds. Anyone have
> any experience in using wire vs. clamps?
>
I suggest you use nylon cable ties instead. They are much lighter and will
effect the balance to a much lesser degree and they are even easier to install.
Just nip off the tail once they are tight.
I use them on half shaft gaiters, CV joint gaiters and steering rack gaiters.
Cheers
Dave
|