> As I tear into our TR-4's engine and remove the head, how many sleeve
> retainers do I need to fabricate, 2 or 4? Looking at the manuals
> I have it
> shows them between pairs if sleeves. Do they go one between 1&2 and one
> between 3&4, or does one go on each side of the pair, two between
> 1 & 2, and
> two more between 3 & 4?
Ron, I wouldn't bother fabricating anything, just slide a suitable stack of
1/2" drive sockets over the stud and spin a head nut down on them. It only
takes two retainers.
If you don't turn the crank with the head off, or are planning on removing
the liners anyway, then there's no need for retainers.
Randall
|