I've been in lurk mode for a while but I couldn't resist-------
All skirts should go up!!!
Don Malling wrote:
There was some discussion as to whether the "skirt" on the trunion grease seal
should go up or go
down. My original TR250 trunion grease seal has it's "skirt" going down -- on
the trunion.
Moss lists the same part number for the TR250/TR6 trunion grease seal and the
REPLACEMENT TR3
trunions. The original TR3 grease seal that goes with an original TR3 trunion
is not the same part
number.
Don Malling
IMPORTANT NOTICE: This e-mail is meant only for the use of the intended
recipient. It may contain confidential information which is legally
privileged or otherwise protected by law. If you received this e-mail
in error or from someone who was not authorized to send it to you, you
are strictly prohibited from reviewing, using, disseminating,
distributing or copying the e-mail. PLEASE NOTIFY US IMMEDIATELY OF THE
ERROR BY RETURN E-MAIL AND DELETE THIS MESSAGE FROM YOUR SYSTEM. Thank
you for your cooperation.
|