Mark:
There is a special tool that ST used. The technique I used on my '70 TR6 was
to place a small piece of duct tape on the trim where I wanted the clip to
go. Which gave a bit more "grip" for the clip than just eh plastic trim. I
then used the metal paint can opener they give you at paint shops to pull up
on the clip to secure it. I have also heard of folks using the old port
cover plate of a computer, bending the one end up to form a hook as a
devise. This is one of those PIA jobs with the TR6. Good luck.
Scott Suhring
Mechanicsburg, PA
'70 TR6
'59 TR3
-----Original Message-----
From: owner-triumphs@autox.team.net
[mailto:owner-triumphs@autox.team.net]On Behalf Of Mark Holder
Sent: Wednesday, September 29, 2004 8:26 PM
To: triumphs@autox.team.net
Subject: Window Trim
I am putting the finishing touches on a 71 TR6 restroation. I am stuck on
the window trim. The clips from Moss were not the same size or style as the
original. They simply do not work. Where can I get the correct clips? Any
tips on installation sure would save some knuckles.
Mark Holder
71 TR6
Mark H
Check out the new British Cars Forum:
http://www.team.net/the-local/tiki-view_forum.php?forumId=8
|