>I don't know if the garden sprayer will handle a 90 weight viscosity but
>I used to ude them to spray automatic transmission fliuf. They worked
>fine for that. Of course if you take the spray tip off they should
>handle any viscosity oil.
>--
> Best Regards,
> Tom
I use a funnel & a piece of clear plastic tubing. I put the funnel
high up in the engine compartment & attach it to a piece of clear
plastic tubing running down into the tranny oil input hole. I slowly
pour the specified amount of oil in the funnel & watch it go down
inside the tubing, When I get to 90% of specified capacity I pour
more slowly & wait for the extra oil to begin to leak out. Go under
the car & pull the hose out of the tranny & put it into an oil bottle
(till it drains) put the plug back in. Clean the funnel & I am done.
John
John A. Wise, Ph.D., CPE
Dept of Distance Education
Embry-Riddle University
5483 West Potter Drive
Glendale, AZ 85308-9334 USA
Tel-hm: (+1) (623) 376-9632
E-mail: Wise@erau.edu
http://home.earthlink.net/~johnwise
Check out the new British Cars Forum:
http://www.team.net/the-local/tiki-view_forum.php?forumId=8
|