I had a thread last week on the figure of 8 gaskets and decking the
liners. Randall suggested I contact Gasket Works (thanks Randall).
Mordy suggested I buy some brass shim, I have done this in both .010
and .012, one of these should produce the deck height I need. My
question is, does anyone have suggestions on how to cut out the
gaskets, I am going to cut individual rings as opposed to the figure
of 8. I guess I need some type of cutting dividers, right?
John
--
John Gillis
1954 TR2 TS3618. October 1954 (ground up)
2001 Kawasaki W650
Trinity College
Dublin,
IRELAND.
|