In a message dated 5/19/2004 3:14:03 PM Eastern Daylight Time, dwillner@ptd.net
writes:
> I'm re-rebuilding my master this week and want to put some new lines in. The
> one from the mc to the fluid tank has some good size bends in it. Not having
> bent this tubing before, is there an easy way to do this to avoid damaging
> it or to make it go easier? Txs
Just bend it around something solid, like a piece of pipe or beer bottle ;-) or
whatever is handy and about the right diameter for the bend you seek.
--Andy Mace
|