I am re-installing the body mounts on my TR3, in the engine compartment
on the 45 degree part. The MOSS parts catalog shows an aluminum spacer with
a thick rubber washer on each side. I ordered new spacers and rubber
washers. Together they are about 7/8 inch thick and the gap is about 3/8
inch, if that. It doesn't look like the body has sagged, slid forward or
anything. I have a bunch of thin rubber washers that I could use instead
that would fit. Would this be alright? Should I jack the body up a bit and
try to get the thicker washers in? What have other listers had to do?
When I took the originals out, there was the aluminum spacer and one
thick rubber washer, I believe. The rubber washer had turned to goo and was
oozing out.
Help! TIA! I am planning on bolting it up tonight.
Bill Brewer
Tehachapi, CA
|