List, as you can see from my subject line I'm trying to rope in a windshield.
I'm having trouble. I started at the bottom center and by the time I got to
the top corners it was clear that the seal was not going to fall into the
opening let alone allow me to rope the inner lip over. I suspect that I should
have started at the top and worked to the bottom. Anybody been there and done
that who will offer advice?
Have you used any type of caulk? I used some butyl rope made for windshields
and rolled it to about a 1/4 diameter. It seemed just like the stuff I
removed. Is that too big and maybe causing a problem?
I did my Surrey Hardtop this winter with no problems and it has much smaller
radius's to deal with so this has me stumped.
TIA
Jerry Van Vlack
|