Peter,
You don't mention which car you are doing. I suspect it's the TR4A with the
raised opening. All of the center support covers that I've seen advertised
say the re-cover kits will not work on that style center support. It happens
to be the one that I have in my car so I'm trying to take good care of the
one I have.
JVV
----- Original Message -----
From: "Kentech Motorsports" <kentech@midmaine.com>
To: <triumphs@autox.team.net>
Sent: Monday, May 03, 2004 5:30 PM
Subject: Moss dash support cover
> I am attempting to install a new dash support cover from Moss, doing a
> trial fit before gluing it down, but the hole in the new cover around
> the shifter boot hole is larger than the dash support and the aluminum
> support shows around the inside edge of the cover. The original cover
> wrapped around and covered the shifter hole and completely covered the
> aluminum. I could put the upper rubber boot over the hole and cover the
> ring of aluminum showing but I think the bottom lip of the upper boot is
> supposed to nest inside of the lower shifter boot so both would be lay
> underneath the dash support when installed correctly. Any suggestions?
> Has anyone had similar experience with the Moss part?
>
> PeterK
> Manchester, ME
|