I installed new diaphrams and needles in the carbs today, even fixed my
sticking linkage.
Now I'am in the process or trying to install a new clutch master cylinder
on the 6
that arrived yesterday from TRF winter sale.
The problem is getting the pipe fitting loose.
Because of the brake servo, its almost impossible to get a wrench on the
pipe.
Its been soaking in bolt blaster for awhile.
Is there a special wrench needed or , must I remove the brake servo to get
a
wrench on this sucker; as it looks
like I'am going to have to do.
thanks
Al Salvatore
76tr6
|