Bob, Don and list
You might try Stockton Wheel. They are able to straighten both alluminum
and steel wheels. On a related note, they are also able to put a wider rim
on an OEM center. That means that you could have a 7" wide wheel on a
factory center and could have it done in any offset that you want. They can
be reached in Stockton, CA at 209/464-7771. Web site is
www.stocktonwheel.com Hope this helps someone out.
Michael Hutchinson
'71 TR6 (the Lazarus project)
> Hi Bob and list,
>
> I assume from this thread there is no place to get new original TR6
> steel wheels?
>
> Can the old ones be straighten? Usually, rarely? My local tire places
> seem to think that they can only be straightened if the bead lip is
> pushed outward. Can't straighten much else -- wobbles etc. Can anyone
> suggest a shop in the northeast or anywhere that can do more?
>
> Lastly, I asked the following question once before and don't think I got
> an answer -- at least maybe not a completely definitive one.
>
> I would like to use Wire Wheels with 6mm (.236") spacers and the long
> (steel wheel) studs on a TR250 and TR6. These would be the 72 spoke 6"
> Daytons listed for the TR250 and TR6. I think TR250 came with 4.5" 60
> spoke wires?. Thus the question -- since I'm already going from stock
> 4.5" wires to 6" wires, does the additional 6mm spacer (2.36") cause
> trouble?
>
>
> Thanks,
>
> Don Malling
|