> Randall: The sleeves are designed to protrude 3 to 5 thousands above the
> block surface, Before you deck the block, measure the heighth of the
> sleeves. If they are at 3,000th you could take 2,000th off the block and
> still be safe.
Bob, I either don't understand you, or I don't agree. The .003" to .005"
protrusion is important, without it the head gasket will likely leak
compression. BTDT.
> I recommend you remove the sleeves after dipping the block
> and replace your figure 8 gaskets.
I'm personally not a believer in dipping the block in the first place, but
if you do, I'd suggest removing the liners first so that their seat in the
block gets cleaned.
Randall
|