> The bad news is that the new u-joint in each assembly was, for some
> reason known only to them, only half assembled. So now, I get to put a
> couple of spiders in their yokes, which I've done before, but never
> well, and never with any fondness
>
> Started the first one last night, and of course, both cups are in, but
> the second one won't fully seat. I used the socket-vice combination,
> but the last cup doesn't want to seat much farther in than flush with
> the yoke. I didn't really crank on the vice, because it's not a very
> big or good one. Any suggestions (before I send this out to my
> local shop)?
Take it back apart, put the roller back where it belongs, smear some more
grease on it, be more careful next time.
Randall
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|