Rich,
I think that the only front bar factory installed on a TR6 was 11/16"
diameter (some say 5/8"). There was no front bar on the TR250. Aftermarket
choices are/were a 7/8" bar from Addco, a 3/4" bar from Pacesetter (no
longer made), a 7/8" or 1.0" bar from Saner Performance, a 7/8" bar from
Moss Europe, a 7/8" bar from Revington TR (in the UK), and a 7/8" bar from
Good Performance. The larger front bars should be used with an
appropriately sized rear bar (according to the above vendors).
Hugh Barber
Hollister, CA
'73 TR6
-----Original Message-----
From: owner-triumphs@autox.team.net
[mailto:owner-triumphs@autox.team.net]On Behalf Of Rikrock@aol.com
Sent: Tuesday, June 03, 2003 4:34 PM
To: triumphs@autox.team.net
Subject: TR-6 Front ARB sizes?
Hello,
I need to know what diameter front bar was fitted by the factory or dealer.
>From the smallest to the fattest, over the years, what sizes were
available?
Thanks!
Rich Rock
Pottstown, PA
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|