"ptegler@cablespeed" wrote:
>
> OK... who know which is the 'best' head gasket
> to use on a GT6. Took Big Red out for a run after
> replacing the head gasket. Compression was up
> so I figure the gasket I just used must have been thinner
> (up from 160 to 170-175 across the board)
>
> Problem is now I have oil AND a water leak coming
> out from under the back of the head.
>
> Suggestions? Wise-cracks? serious help?
>
> Paul Tegler
> ptegler@cablespeed.com
> www.teglerizer.com
Paul,
Did you remember to retorque the head AFTER bringing it up top operating
temperature. If not, that is likely the source of the trouble.
Joe
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|