In a message dated 2/20/2003 7:18:15 PM Eastern Standard Time,
ahwahnee@cybertrails.com writes:
> I use a hole punch (about 3/16") that came with a set of Xacto knives.
> There are many sources for these, get one that is pretty sharp. You use
> this for both snaps and lift-the-dot (LTD).
George, a bit of clarification, please. Are you saying that you also punch a
3/16" hole for the snaps? Seems way large to me for snaps, albeit fine for
the Lift-the-dots. I've always used just a sharp awl or similar tool to make
a hole JUST big enough for the snap piece to fit through snugly.
But, your mileage may vary! ;-)
--Andy Mace
*Mrs Irrelevant: Oh, is it a jet?
*Man: Well, no ... It's not so much of a jet, it's more your, er,
Triumph Herald engine with wings.
-- Cut-price Airlines Sketch, Monty Python's Flying Circus (22)
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|