I'm getting ready to re-assemble the steering column on my TR4A (I believe
this applies to any TR4-6). The factory manual says "using the 1/8" UF
Unbreako hexagon wrench", to tighten the setscrew as tight as possible
without bending the wrench (so I guess that's tighten until it bends, then
back of a little?). Anyway, is there any reason to expect that an
"Unbreako" Allen wrench is anything special? Should I just tighten it as
much as I can with my regular old Allen wrench?
--
Darrell Walker
66 TR4A IRS CTC67956L
Vancouver, WA, USA
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|