> The metal part (outer sleeve) of the bush wants to stay in each
> end of the
> center tie rod and apparently I will need to press them out. The pin and
> rubber bush has been removed. I removed the center tie rod from
> the vehicle.
> Any suggestions on how to remove these sleeves?
One way is to assemble a hacksaw through the hole, and cut most of the way
through the sleeve. Then a sharp chisel and BFH to drive the sleeve out.
> Will heat help?
I don't think so.
Randall
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|