I have used a piece of plastic pipe big enough to fit over the bushing and
deep enough to hold the bushing, ( about 2" deep), a socket, and a big
vise or C-clamp, the vise is easier. put the board over end of pipe, push
old bushing with socket out into pipe.
If that fails I do have a set of trailing arms with uprated bushings already
installed, for sale.
cheers
Al Salvatore
76tr6
----- Original Message -----
From: "Darrell Walker" <darrellw@inetarena.com>
To: "jack williams" <jackandangie@attbi.com>; "tr list list"
<triumphs@autox.team.net>
Sent: Saturday, December 28, 2002 3:24 PM
Subject: Re: trailing arm bushings
> On 12/28/02 8:41 AM, "jack williams" <jackandangie@attbi.com> wrote:
>
> > Okay folks, I've got my new trailing arm bushings in an I'm going to
install
> > them hopefully today. I have no doubt I can do the job, but if there is
any
> > collective wisdom out there from people that have been there done that,
it
> > would be appreciated. I'd like to do this as easy as possible, and I
figure
> > some of you have found some shortcuts/easier ways to get the job done.
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|