Re: casting project proposal - easier than an engine head

["William Davies" <bill@rarebits4classics.co.uk>]

----- Original Message ----- 
From: aribert <aribert@c3net.net>
> 
> If aluminum, might I suggest casting the TR6/GT6 water pump body (this
> is
> the cast iron distribution manifold) that the water pump (assy) mounts
> into.  This would be a much easier and more manageable part to make than
> a head.  

Is this a different casting to the 4 cylinder type which Canley Classics are 
manufacturing in aluminium?
    Cheers,
        Bill.

--
Rarebits4classics
       .......just what you've been looking for

PO Box 1232
Calne
Wiltshire
SN11 8WA
United Kingdom
http://www.rarebits4classics.co.uk

///  triumphs@autox.team.net mailing list
///  or try  http://www.team.net/cgi-bin/majorcool
///  Archives at http://www.team.net/archive