Hello List:
Have an early TR engine without the later engine improvement of a full set
of cam bearings installed. Anyone have an idea of how difficult it would be
to re-fit the block with a set of cam bearings?
Have visions of the need to line-bore the block, etc.,etc. Can you use the
stock TR2 cam?
Would it be worth going through all of this? The thought of having the cam
run in the casting just doesn't sit too well with me.
Thanks for any insights.
Angelo Graham
54/55? TR2
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|