Hi Rob. I'm not sure what lengths go where, but be careful. Getting them wrong
can damage the bodywork. I put a too long bolt in one of the bonnet side holes
and it dimpled the outside of the bonnet.
- Hugh Fader
"Rob Christopher" <robc@cisco.com> wrote:
> Hey everyone,
>
> The carcass of my TR6 is at the bodyshop getting a new front clip grafted
> on. Soon, the bonnet will have to be test fit. I had to cut the bonnet
> hinge bolts to get the crumpled one off the car two years ago so they are
> long since gone in the trash.
>
> According to Nelson's(?) terrific spreadsheet, I need 2 - 5/16"x1/2", 6 -
> 5/16"x7/8", 2 - 5/16"x1", and 2 - 5/16"x1 1/2" UNF bolts. Can anyone
> describe where the various lengths actually go? There are 2 at the hinge
to
> headlight cup connection, 6 at the hinge to bonnet underside connection,
and
> 2 more at the hinge to bonnet side connection. That's two less than called
> for on the spread sheet.
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|