In a message dated 10/23/02 10:53:56 AM Eastern Daylight Time,
galahad@uslink.net writes:
> However, his comment about the muffler bearing is amazingly wrong; it is
> almost always the bicubic spline interpolator.
>
I think it depends on the specific gravity of the fluif in the muffler
and the specific heat of the spline interpolator
Cheers
Jack "i was a chemistry major in college, but haven't thought about
this stuff in about 25 years" Mc
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|